Press Center
 
Home About us Products Support Quality & Certification Career Contact us
• Power Management
    Linear Regulators
    Low Dropout Linear Regulators
    DDR Termination Regulators
    Shunt Reference Regulators
    Step Down Switching Regulators
    Switching Regulator
    Step-Up DC-DC Converter
    PWM Controller
    White LED Driver
    Supervisory Circuit
    Voltage Detection and System R
    USB Power Switch
    Power Factor Control
    Li-Battery Protection or Charg
    FET Bias Controllers
    Combo IC
    Inverting DC-DC Converter
• Amplifier / Comparator
    Audio Amplifiers
    Operational Amplifier
    Voltage Comparator
• Analog Switches
    Video Signal Switch
    Analog Multiplexers, Demultipl
• Hall ICs
• Special Application ICs
    Motor Controller IC
    Interface and Driver Circuit
    Telecommunication Circuit
    Melody IC
    Alarm /Sound Generator IC
    Remote Controller IC
    Television Circuit
    Leakage Current Detector
    Automotive IC
    A-D or D-A Converters
    Miscellaneous
    Radio and Cassette Recorder Ci
    Timer
    Mouse&Keyboard Controller
    Transient Voltage Suppressors
    Sense Monitor
    Video Filter
    ZCB snubber
• Logic
• TRANSISTORs
• MOSFETs
    JFET
    Power Mosfet
• TRIACs
• SCRs
• DIODEs
 
Home >
ME7660 Datasheet

 
CHARGE PUMP DC-DC VOLTAGE CONVERTER
 
 

DESCRIPTION
 
ME7660 is a charge pump DC-DC voltage converter using
AL-gate CMOS technology and optimization design. It converters a
+1.5V to +10V input to a corresponding -1.5V to -10V output using only
two external capacitors, eliminating inductors and their associated
cost, size and EMI. The on-board oscillator operates at a nominal
frequency of 10KHZ. Operation below 10 KHZ (for lower supply current
applications) is possible by connecting an external capacitor from OSC to ground.
 
 
FEATURES
 
 
* Converts +5V Logic supply to +5V
* Wide input voltage range:1.5V~10V
* Efficient voltage conversion:99.9%
* Good power efficiency:98%
* Low power supply:50uA@5Vin
* Only two external capacitors required
* Compatible with RS232 negative power supply standard
* No Dx diode needed for high voltage operation
About us  |  Products  |  Contact us
Copyright 2011 UTC All received