Press Center
Home About us Products Support Quality & Certification Career Contact us
• Power Management
    Linear Regulators
    Low Dropout Linear Regulators
    DDR Termination Regulators
    Shunt Reference Regulators
    Step Down Switching Regulators
    Switching Regulator
    Step-Up DC-DC Converter
    PWM Controller
    White LED Driver
    Supervisory Circuit
    Voltage Detection and System R
    USB Power Switch
    Power Factor Control
    Li-Battery Protection or Charg
    FET Bias Controllers
    Combo IC
    Inverting DC-DC Converter
• Amplifier / Comparator
    Audio Amplifiers
    Operational Amplifier
    Voltage Comparator
• Analog Switches
    Video Signal Switch
    Analog Multiplexers, Demultipl
• Hall ICs
• Special Application ICs
    Motor Controller IC
    Interface and Driver Circuit
    Telecommunication Circuit
    Melody IC
    Alarm /Sound Generator IC
    Remote Controller IC
    Television Circuit
    Leakage Current Detector
    Automotive IC
    A-D or D-A Converters
    Radio and Cassette Recorder Ci
    Mouse&Keyboard Controller
    Transient Voltage Suppressors
    Sense Monitor
    Video Filter
    ZCB snubber
• Logic
    Power Mosfet
• SCRs
Home > PWM Controller
UC3875A Datasheet







The UTC UC3875A is a high performance current mode PWM

controller ideally suited for low standby power. The PWM switching

frequency is programmable externally at normal operation. Low

VDD startup current make the power reliable on startup design and

a large value resistor could be  used in the startup circuit to

minimize the standby power. At no  load condition, the IC operates

in power-saving mode for lower standby power, decreasing

frequency for Higher conversion efficiency at light load condition.

The UTC UC3875A contains protection with automatic recovery

including OLP (over load protection), OTP (over temperature

protection), OVP (over voltage protection), UVLO (VDD over voltage clamp and under voltage lockout).To protect the

power MOSFET, Gate-drive output is fixed up to 16V max. The UTC  UC3875A contains protection OCP

(cycle-by-cycle current limiting).

The internal slope FBensation improves system stability at high PWM duty cycle output. Leading-edge blanking

on current sense input removes the signal glitch, which  offering minimal external FBonent count in the design.

Excellent EMI performance is achieved with UTC proprietary frequency hopping technique (ZL201020615247.1)

together with soft driver control.  Audio noise is eliminated due to switch frequency more than 20kHz during


The UTC UC3875A has such applications as: battery charger, power adaptor, set-top box power supplies, ink jet

printers, open-frame SMPS.




* UTC proprietary frequency hopping technology for Improved EMI


* Power-saving mode for high light-load and standby efficiency

* Dynamic peak current limiting for constant output power

* Built-in synchronized slope FBensation

* OTP,OLP,OVP and VDD clamp for higher security

* Programmable PWM Frequency

* Gate output voltage clamped at 16V

* Low start-up current

* Cycle-by-cycle Current Limiting

* Under voltage lockout (UVLO)

* Few external FBonents required

About us  |  Products  |  Contact us
Copyright 2011 UTC All received