Press Center
Home About us Products Support Quality & Certification Career Contact us
• Power Management
    Linear Regulators
    Low Dropout Linear Regulators
    DDR Termination Regulators
    Shunt Reference Regulators
    Step Down Switching Regulators
    Switching Regulator
    Step-Up DC-DC Converter
    PWM Controller
    White LED Driver
    Supervisory Circuit
    Voltage Detection and System R
    USB Power Switch
    Power Factor Control
    Li-Battery Protection or Charg
    FET Bias Controllers
    Combo IC
    Inverting DC-DC Converter
• Amplifier / Comparator
    Audio Amplifiers
    Operational Amplifier
    Voltage Comparator
• Analog Switches
    Video Signal Switch
    Analog Multiplexers, Demultipl
• Hall ICs
• Special Application ICs
    Motor Controller IC
    Interface and Driver Circuit
    Telecommunication Circuit
    Melody IC
    Alarm /Sound Generator IC
    Remote Controller IC
    Television Circuit
    Leakage Current Detector
    Automotive IC
    A-D or D-A Converters
    Radio and Cassette Recorder Ci
    Mouse&Keyboard Controller
    Transient Voltage Suppressors
    Sense Monitor
    Video Filter
    ZCB snubber
• Logic
    Power Mosfet
• SCRs
Home >
RCR02 Datasheet

Decoder For Remote Controller With Five Functions
The chip can be used with the encoder RCT02 to provide a
complete control functions to the remote-controlled toy. The
RCR02 has five output pins corresponding with the five
function actions i.e, forward, backward, rightward, leftward
and turbo. The received signals are amplified by the
three-stage amplifier, and then the appropriate amplified
signals are sampled, fault-tolerantly checked and decoded to
control the actions of the remote-controlled toy.
There is an internal oscillator in the RCR02.By adding an
external resistor conveniently, the oscillator will be
constructed. The oscillator frequency can be adjusted by the
external resistor.The relative error between the frequencies of
the two on chip oscillators in the RCT02 and RCR02 must be less than ±25%.
*Five output pins for control functions
*Operating power-supply voltage range: 2.5 to 5.0V
*On-chip reversing amplifiers
*On-chip oscillator with an external resistor
*Low operating current
*Few external components needed
About us  |  Products  |  Contact us
Copyright 2011 UTC All received