Press Center
Home About us Products Support Quality & Certification Career Contact us
• Power Management
    Linear Regulators
    Low Dropout Linear Regulators
    DDR Termination Regulators
    Shunt Reference Regulators
    Step Down Switching Regulators
    Switching Regulator
    Step-Up DC-DC Converter
    PWM Controller
    White LED Driver
    Supervisory Circuit
    Voltage Detection and System R
    USB Power Switch
    Power Factor Control
    Li-Battery Protection or Charg
    FET Bias Controllers
    Combo IC
    Inverting DC-DC Converter
• Amplifier / Comparator
    Audio Amplifiers
    Operational Amplifier
    Voltage Comparator
• Analog Switches
    Video Signal Switch
    Analog Multiplexers, Demultipl
• Hall ICs
• Special Application ICs
    Motor Controller IC
    Interface and Driver Circuit
    Telecommunication Circuit
    Melody IC
    Alarm /Sound Generator IC
    Remote Controller IC
    Television Circuit
    Leakage Current Detector
    Automotive IC
    A-D or D-A Converters
    Radio and Cassette Recorder Ci
    Mouse&Keyboard Controller
    Transient Voltage Suppressors
    Sense Monitor
    Video Filter
    ZCB snubber
• Logic
    Power Mosfet
• SCRs
Home > Interface and Driver Circuit
LS3718 Datasheet

The UTC LS3718 is a 20-bit serial to parallel converter utilizing
CMOS Technology. It is incorporates control circuit, shift register,
latch and driver into a single ship. It is suitable for MCU interface.
The effective interface assignment of MPU is available as the
connection between UTC LS3718 and MPU is required only 4 lines.
   The device is designed to operate up to 5MHz. When the serial
data input to the DATA terminal and the data is output from parallel
output buffer through serial in parallel out shift register and parallel data latches.
 The data can through the shift register serial output to the SO
terminal. Therefore the UTC LS3718 can cascade connection to
expand the output data number.
The hysteresis input circuit realizes wide noise margin and the
high drive-ability output buffer (25mA) can drive LED directly.

* 20-Bit serial in parallel out
* Cascade connection
* Operating voltage      5V±10%
* Hysteresis input        0.5V typ
* Output current         25mA
* Operating frequency    5MHz or more
About us  |  Products  |  Contact us
Copyright 2011 UTC All received