Press Center
 
Home About us Products Support Quality & Certification Career Contact us
• Power Management
    Linear Regulators
    Low Dropout Linear Regulators
    DDR Termination Regulators
    Shunt Reference Regulators
    Step Down Switching Regulators
    Switching Regulator
    Step-Up DC-DC Converter
    PWM Controller
    White LED Driver
    Supervisory Circuit
    Voltage Detection and System R
    USB Power Switch
    Power Factor Control
    Li-Battery Protection or Charg
    FET Bias Controllers
    Combo IC
    Inverting DC-DC Converter
• Amplifier / Comparator
    Audio Amplifiers
    Operational Amplifier
    Voltage Comparator
• Analog Switches
    Video Signal Switch
    Analog Multiplexers, Demultipl
• Hall ICs
• Special Application ICs
    Motor Controller IC
    Interface and Driver Circuit
    Telecommunication Circuit
    Melody IC
    Alarm /Sound Generator IC
    Remote Controller IC
    Television Circuit
    Leakage Current Detector
    Automotive IC
    A-D or D-A Converters
    Miscellaneous
    Radio and Cassette Recorder Ci
    Timer
    Mouse&Keyboard Controller
    Transient Voltage Suppressors
    Sense Monitor
    Video Filter
    ZCB snubber
• Logic
• TRANSISTORs
• MOSFETs
    JFET
    Power Mosfet
• TRIACs
• SCRs
• DIODEs
 
Home > PWM Controller
TL5001 Datasheet

PULSE-WIDTH-MODULATION CONTROL CIRCUITS


 
DESCRIPTION
 
   The UTC TL5001 incorporates on a single monolithic chip all the
functions required for a pulse width modulation (PWM) control circuit.
Designed primarily for power-supply control, It contains an error
amplifier, a regulator, an oscillator, a PWM comparator with a
dead-time-control input, undervoltage lockout (UVLO), short-circuit
protection (SCP), and an open-collector output transistor.
The error-amplifier common-mode voltage ranges from 0V to 1.5V.
The noninverting input of the error amplifier is connected to a 1-V
reference. Dead-time control (DTC) can be set to provide 0% to
100% dead time by connecting an external resistor between DTC
and GND. The oscillator frequency is set by terminating RT with an
external resistor to GND. During low Vcc conditions, the UVLO
circuit turns the output off until Vcc recovers to its normal operating range.
 



 
FEATURES
 
*Complete PWM power control  
*3.6-V to 40-V operation
*Internal under voltage-lockout circuit
*Internal short-circuit protection
*Oscillator frequency : 20kHz to 500kHz
*Variable dead timer provides control over total range
About us  |  Products  |  Contact us
Copyright 2011 UTC All received