Press Center
Home About us Products Support Quality & Certification Career Contact us
• Power Management
    Linear Regulators
    Low Dropout Linear Regulators
    DDR Termination Regulators
    Shunt Reference Regulators
    Step Down Switching Regulators
    Switching Regulator
    Step-Up DC-DC Converter
    PWM Controller
    White LED Driver
    Supervisory Circuit
    Voltage Detection and System R
    USB Power Switch
    Power Factor Control
    Li-Battery Protection or Charg
    FET Bias Controllers
    Combo IC
    Inverting DC-DC Converter
• Amplifier / Comparator
    Audio Amplifiers
    Operational Amplifier
    Voltage Comparator
• Analog Switches
    Video Signal Switch
    Analog Multiplexers, Demultipl
• Hall ICs
• Special Application ICs
    Motor Controller IC
    Interface and Driver Circuit
    Telecommunication Circuit
    Melody IC
    Alarm /Sound Generator IC
    Remote Controller IC
    Television Circuit
    Leakage Current Detector
    Automotive IC
    A-D or D-A Converters
    Radio and Cassette Recorder Ci
    Mouse&Keyboard Controller
    Transient Voltage Suppressors
    Sense Monitor
    Video Filter
    ZCB snubber
• Logic
    Power Mosfet
• SCRs
Home >
PA3202 Datasheet



The UTC PA3202 is a monolithic integrated circuit that stereo
bridged audio power amplifiers capable of producing 2 W into 3Ω
with a 5V supply voltage or 800mW into 3Ω with a 3.3V supply
voltage .The UTC PA3202 simplifies design and frees up board
space for other features. Both of the depop circuitry and the
thermal shutdown protection circuitry are integrated in UTC
PA3202, that reduce clicks and pops noise during power up or
shutdown mode operation.
A MUX control terminal ) LINE / HP ( allows selection between
the two sets of stereo input signals. To simplify the audio system
design, UTC PA3202 combines a stereo bridge-tied loads (BTL)
mode for speaker drive and a stereo single-end (SE) mode for
headphone drive into a single chip, where both modes are easily
switched by the BTL / SE   input control pin signal.

* Improves depop circuitry to eliminate turn-on and turn-off
transients in output
* Output power:
 -2W(typ.)@5V into 3Ω with 0.2% THD+N max (1kHz)
 -800mW(typ.)@3.3V into 3Ω with 0.2% THD+N max (1kHz)
* Fully specified for use with 3-Ω Loads
* Stereo switchable bridged/single-ended power amplifiers
* Input MUX select terminal
* Thermal-shutdown protection
* Shutdown mode available
About us  |  Products  |  Contact us
Copyright 2011 UTC All received