Press Center
 
Home About us Products Support Quality & Certification Career Contact us
• Power Management
    Linear Regulators
    Low Dropout Linear Regulators
    DDR Termination Regulators
    Shunt Reference Regulators
    Step Down Switching Regulators
    Switching Regulator
    Step-Up DC-DC Converter
    PWM Controller
    White LED Driver
    Supervisory Circuit
    Voltage Detection and System R
    USB Power Switch
    Power Factor Control
    Li-Battery Protection or Charg
    FET Bias Controllers
    Combo IC
    Inverting DC-DC Converter
• Amplifier / Comparator
    Audio Amplifiers
    Operational Amplifier
    Voltage Comparator
• Analog Switches
    Video Signal Switch
    Analog Multiplexers, Demultipl
• Hall ICs
• Special Application ICs
    Motor Controller IC
    Interface and Driver Circuit
    Telecommunication Circuit
    Melody IC
    Alarm /Sound Generator IC
    Remote Controller IC
    Television Circuit
    Leakage Current Detector
    Automotive IC
    A-D or D-A Converters
    Miscellaneous
    Radio and Cassette Recorder Ci
    Timer
    Mouse&Keyboard Controller
    Transient Voltage Suppressors
    Sense Monitor
    Video Filter
    ZCB snubber
• Logic
• TRANSISTORs
• MOSFETs
    JFET
    Power Mosfet
• TRIACs
• SCRs
• DIODEs
 
Home >
PA3312 Datasheet

DUAL 2.6W AUDIO POWER AMPLIFIER WITH FOUR SELECTABLE GAIN SETTINGS AND INPUT-MUX CONTROL      
 
 
DESCRIPTION

The UTC PA3312 is a monolithic integrated circuit that stereo
bridged audio power amplifiers capable of producing 2.6W into 3Ω
with less than 10% THD+N or 1W into 8Ω with less than 0.65%
THD+N. This device minimizes the number of external components
needed, simplifying the design, and freeing up board space for
other features. Both of the depop circuitry and the thermal
shutdown protection circuitry are integrated in UTC PA3312, that
reduce pops and clicks noise during power up or shutdown mode operation .
Amplifier gain is internally configured and controlled by way of
two terminals (GAIN0 and GAIN1). BTL gain setting of 6 dB, 10 dB,
15.6dB, 21.6dB (inverting) are provided, whereas SE gain is
always configured as 4.1dB for headphone drive. A MUX control
terminal (HP/LINE) allows selection between the two sets of stereo
input signals. To simplify the audio system design, UTC PA3312
combines a stereo bridge-tied loads (BTL) mode for speaker drive
and a stereo single-end (SE) mode for headphone drive into a
single chip, where both modes are easily switched by the SE/BTL input control pin signal.
 

 
FEATURES
 
* Low operating current with 10mA  
* Compatible with pc 99 desktop line-out into 10KΩ load  
* Internal gain control ,which eliminates external gain-setting resistors 
* 2.6w per channel output power into 3Ω at 5V , BTL mode  
* Input MUX select terminal  
* Pc-beep input  
* Improves depop circuitry to eliminate turn-on and turn-off transients in output  
* Fully differential input  
About us  |  Products  |  Contact us
Copyright 2011 UTC All received