Press Center
Home About us Products Support Quality & Certification Career Contact us
• Power Management
    Linear Regulators
    Low Dropout Linear Regulators
    DDR Termination Regulators
    Shunt Reference Regulators
    Step Down Switching Regulators
    Switching Regulator
    Step-Up DC-DC Converter
    PWM Controller
    White LED Driver
    Supervisory Circuit
    Voltage Detection and System R
    USB Power Switch
    Power Factor Control
    Li-Battery Protection or Charg
    FET Bias Controllers
    Combo IC
    Inverting DC-DC Converter
• Amplifier / Comparator
    Audio Amplifiers
    Operational Amplifier
    Voltage Comparator
• Analog Switches
    Video Signal Switch
    Analog Multiplexers, Demultipl
• Hall ICs
• Special Application ICs
    Motor Controller IC
    Interface and Driver Circuit
    Telecommunication Circuit
    Melody IC
    Alarm /Sound Generator IC
    Remote Controller IC
    Television Circuit
    Leakage Current Detector
    Automotive IC
    A-D or D-A Converters
    Radio and Cassette Recorder Ci
    Mouse&Keyboard Controller
    Transient Voltage Suppressors
    Sense Monitor
    Video Filter
    ZCB snubber
• Logic
    Power Mosfet
• SCRs
Home >
US204 Datasheet

The UTC US204 series are 100mΩ high-side power switches.
There are internal duel low voltage N-Channel MOSFETS which whish is ideal all USB applications. These MOSFETS is driven by a charge pump circuitry inside, these switches on resistance are as low as 100mΩ which and meet the drop voltage for USB
The flag pins output an open-drain fault flag to next controller.
There’re lots internal special ways for protecting the chip’s operation. There are also built-in protection circnits to ensure the chips function normally.
When in hot-plug events, there’s large current which can create the upstream voltage droop to match the USB’s voltage droop requirements and soft-start for isolating the power source.
As soon as the die temperature is higher than 130, the internal shutdown circuit will work.
Only when there’s a normal input voltage in the VIN pin, the UVLO (under-voltage lockout, 2.1V typ.) can make sure the chip is in the off state.
Because of the requirement of USB power, the fault current should be ensured to be less than 1.5A for UTC US204AH/AL and 1.0A for UTC US204CH/CL.


* 100mΩ(Typ) N-Channel MOSFET
* Supply Current:
– Switch On : 60μA (Typ)
– Switch Off : 1μA (Typ)
* Load Current 1.5A for US204AH/AL and 1.0A for US204CH/CL
* Input Voltage from 2V ~ 5.5V
* In Off-State: Output Voltage can be Higher than Input
About us  |  Products  |  Contact us
Copyright 2011 UTC All received