Press Center
Home About us Products Support Quality & Certification Career Contact us
• Power Management
    Linear Regulators
    Low Dropout Linear Regulators
    DDR Termination Regulators
    Shunt Reference Regulators
    Step Down Switching Regulators
    Switching Regulator
    Step-Up DC-DC Converter
    PWM Controller
    White LED Driver
    Supervisory Circuit
    Voltage Detection and System R
    USB Power Switch
    Power Factor Control
    Li-Battery Protection or Charg
    FET Bias Controllers
    Combo IC
    Inverting DC-DC Converter
• Amplifier / Comparator
    Audio Amplifiers
    Operational Amplifier
    Voltage Comparator
• Analog Switches
    Video Signal Switch
    Analog Multiplexers, Demultipl
• Hall ICs
• Special Application ICs
    Motor Controller IC
    Interface and Driver Circuit
    Telecommunication Circuit
    Melody IC
    Alarm /Sound Generator IC
    Remote Controller IC
    Television Circuit
    Leakage Current Detector
    Automotive IC
    A-D or D-A Converters
    Radio and Cassette Recorder Ci
    Mouse&Keyboard Controller
    Transient Voltage Suppressors
    Sense Monitor
    Video Filter
    ZCB snubber
• Logic
    Power Mosfet
• SCRs
Home > Interface and Driver Circuit
UTRS485 Datasheet

The UTC UTRS485 is a half-duplex transceiver designed for
RS-485 data bus network, which contains one transmitter and one
receiver. The UTC UTRS485 features a fail-safe receiver, which
guarantees the receiver to output high when the receiver inputs are
open, short or idle.  
The UTC UTRS485 also features a hot-swap glitch free protection
circuits which guarantee outputs of both the transmitter and the
receiver in a high impedance state during the power up period. So that
the large short current from power to ground will be disable by glitch
free function, which will save the power and enhance the efficiency of
the power up.  
The UTC UTRS485 is optimized for signal rates up to 2.5Mbps
with differential voltage of 2.3V. The UTC UTRS485 also has the
thermal shutdown function when the temperature is over 150 and
the protection of the current limitation in the transmitter to protect the
itself from the damage by the system-fault conditions during normal
* Meet the requirements of the EIA/TIA-485 standards
* 5.0V single power supply
* 1µA low-current shutdown mode
* True fail-safe receiver while maintaining EIA/TIA-485 compatibility
* Hot-swap glitch free protection on control inputs
* Up to 256 transceivers on the bus
* Driver short circuit current limit
* Thermal shutdown for overload protection  
About us  |  Products  |  Contact us
Copyright 2011 UTC All received