Press Center
Home About us Products Support Quality & Certification Career Contact us
• Power Management
    Linear Regulators
    Low Dropout Linear Regulators
    DDR Termination Regulators
    Shunt Reference Regulators
    Step Down Switching Regulators
    Switching Regulator
    Step-Up DC-DC Converter
    PWM Controller
    White LED Driver
    Supervisory Circuit
    Voltage Detection and System R
    USB Power Switch
    Power Factor Control
    Li-Battery Protection or Charg
    FET Bias Controllers
    Combo IC
    Inverting DC-DC Converter
• Amplifier / Comparator
    Audio Amplifiers
    Operational Amplifier
    Voltage Comparator
• Analog Switches
    Video Signal Switch
    Analog Multiplexers, Demultipl
• Hall ICs
• Special Application ICs
    Motor Controller IC
    Interface and Driver Circuit
    Telecommunication Circuit
    Melody IC
    Alarm /Sound Generator IC
    Remote Controller IC
    Television Circuit
    Leakage Current Detector
    Automotive IC
    A-D or D-A Converters
    Radio and Cassette Recorder Ci
    Mouse&Keyboard Controller
    Transient Voltage Suppressors
    Sense Monitor
    Video Filter
    ZCB snubber
• Logic
    Power Mosfet
• SCRs
Home > Step Down Switching Regulators
UD05104 Datasheet






The UTC UD05104 is a 1A high frequency synchronous Step

Down DC/DC converter using constant frequency, current mode

architecture. The device integrates main switch and synchronous

rectifier switch for high efficiency without an external schottky

diode. To maximize light load efficiency, The UTC  UD05104

draws only 30μA quiescent current to improve light load

efficiency. In shutdown, The UTC  UD05104 reduces supply

current less than 1μA. The UTC UD05104 can supply 1A of load

current from 2.5V to 6.0V input voltage. The output voltage can

be regulated as low as 0.6V. The switching frequency is internally

set at 2.25MHz, as for operation mode: UTC  UD05104 is

automatic PSM/PWM mode.  

The UTC  UD05104  has built-in internal Soft Start, Short

Circuit Protection and OTP functions, allowing the use of small

surface mount inductors and capacitor.




* Input Voltage Range from 2.5V to 6.0V

* +/-2% 0.6V Feedback Voltage Accuracy

* 2.25MHz Switching Frequency      

* Continuous Output Current up to 1A

* Low Quiescent Current of 30µA

* 0.1μA Shutdown Current

* 100% Duty Cycle Operation

* Built-in 170mΩ/150mΩ Power Switch

* Internal Soft-Start

* Cycle-by-Cycle Current Limit Protection

* Over-Load and Hiccup Mode Short Circuit

* Thermal Shutdown Protection   

About us  |  Products  |  Contact us
Copyright 2011 UTC All received