Press Center
 
Home About us Products Support Quality & Certification Career Contact us
• Power Management
    Linear Regulators
    Low Dropout Linear Regulators
    DDR Termination Regulators
    Shunt Reference Regulators
    Step Down Switching Regulators
    Switching Regulator
    Step-Up DC-DC Converter
    PWM Controller
    White LED Driver
    Supervisory Circuit
    Voltage Detection and System R
    USB Power Switch
    Power Factor Control
    Li-Battery Protection or Charg
    FET Bias Controllers
    Combo IC
    Inverting DC-DC Converter
• Amplifier / Comparator
    Audio Amplifiers
    Operational Amplifier
    Voltage Comparator
• Analog Switches
    Video Signal Switch
    Analog Multiplexers, Demultipl
• Hall ICs
• Special Application ICs
    Motor Controller IC
    Interface and Driver Circuit
    Telecommunication Circuit
    Melody IC
    Alarm /Sound Generator IC
    Remote Controller IC
    Television Circuit
    Leakage Current Detector
    Automotive IC
    A-D or D-A Converters
    Miscellaneous
    Radio and Cassette Recorder Ci
    Timer
    Mouse&Keyboard Controller
    Transient Voltage Suppressors
    Sense Monitor
    Video Filter
    ZCB snubber
• Logic
• TRANSISTORs
• MOSFETs
    JFET
    Power Mosfet
• TRIACs
• SCRs
• DIODEs
 
Home > FET Bias Controllers
L8402 Datasheet
  

LOW POWER 4 STAGE FET BIAS CONTROLLER

 

 

DESCRIPTION

 

The UTC L8402 is designed to bias the MOSFETs that are commonly used in LNBs that can implies minimum external components requires. The UTC L8402, provide four FETs bias control respectively. By adjusting two external resistors, it can change the FET’s bias current to optimize the satellite receiver front end block performances. As an additional feature the Rcal pins can also be used as logic inputs to disable pairs of FETs as part of a power management scheme or simply an alternative to LNA switching. Driven to a logic high (>3.0V), the inputs disable their associated FET bias stages by switching gate feeds to 2.5V and drain feeds open circuit. It generates the required negative voltage to bias the gate of FETs, and internally provides protection circuit that can protect the FET devices during supply voltage transient. So it is very popular in satellite receiver front end block.

 

FEATURES

 

* Can Bias up to 4 FETs

* Wide supply voltage range: 3V~8V

* Low quiescent supply current, 1.2mA typical

* FET drain voltages set at 2.0V

* Adjustable FET device operating current

* FET drain voltages and currents held stable over temperature and VCC variations

* Built in FET device protection circuit * Low external component count

About us  |  Products  |  Contact us
Copyright 2011 UTC All received