Press Center
 
Home About us Products Support Quality & Certification Career Contact us
• Power Management
    Linear Regulators
    Low Dropout Linear Regulators
    DDR Termination Regulators
    Shunt Reference Regulators
    Step Down Switching Regulators
    Switching Regulator
    Step-Up DC-DC Converter
    PWM Controller
    White LED Driver
    Supervisory Circuit
    Voltage Detection and System R
    USB Power Switch
    Power Factor Control
    Li-Battery Protection or Charg
    FET Bias Controllers
    Combo IC
    Inverting DC-DC Converter
• Amplifier / Comparator
    Audio Amplifiers
    Operational Amplifier
    Voltage Comparator
• Analog Switches
    Video Signal Switch
    Analog Multiplexers, Demultipl
• Hall ICs
• Special Application ICs
    Motor Controller IC
    Interface and Driver Circuit
    Telecommunication Circuit
    Melody IC
    Alarm /Sound Generator IC
    Remote Controller IC
    Television Circuit
    Leakage Current Detector
    Automotive IC
    A-D or D-A Converters
    Miscellaneous
    Radio and Cassette Recorder Ci
    Timer
    Mouse&Keyboard Controller
    Transient Voltage Suppressors
    Sense Monitor
    Video Filter
    ZCB snubber
• Logic
• TRANSISTORs
• MOSFETs
    JFET
    Power Mosfet
• TRIACs
• SCRs
• DIODEs
 
Home > White LED Driver
L5104 Datasheet
  

1.4A BOOST FOR WHITE LED DRIVER

 

 

DESCRIPTION

 

The UTC L5104 is a high frequency, asynchronous boost
converter. The internal MOSFET can support up to 8 White LEDs
for backlighting and OLED power application, and the internal soft
start function can reduce the inrush current.
The UTC L5104 uses current mode, 1.0MHz fixed frequency
architecture to regulate the LED current, which is set through an
external current sense resistor. Its low 300mV feedback voltage
reduces power loss and improves efficiency. The OVP pin monitors
the output voltage and turns off the converter if an over-voltage
condition is present due to an open circuit condition. The UTC
L5104 includes under-voltage lockout, current limiting and thermal
shutdown protection preventing damage in the event of an output
overload.

FEATURES

* 2.5V~5.5V operating input voltage range
* Drives up to 8 series White LEDs
* 1.0MHz Fixed Switching Frequency
* Wide range for PWM dimming (200Hz~200KHz)
* Internal 1.4A switching current limit
* Over Voltage Protection (OVP)
* Internal Soft-start Function
* Current limit and Thermal shutdown protection
* Under voltage Lockout

About us  |  Products  |  Contact us
Copyright 2011 UTC All received