Press Center
Home About us Products Support Quality & Certification Career Contact us
• Power Management
    Linear Regulators
    Low Dropout Linear Regulators
    DDR Termination Regulators
    Shunt Reference Regulators
    Step Down Switching Regulators
    Switching Regulator
    Step-Up DC-DC Converter
    PWM Controller
    White LED Driver
    Supervisory Circuit
    Voltage Detection and System R
    USB Power Switch
    Power Factor Control
    Li-Battery Protection or Charg
    FET Bias Controllers
    Combo IC
    Inverting DC-DC Converter
• Amplifier / Comparator
    Audio Amplifiers
    Operational Amplifier
    Voltage Comparator
• Analog Switches
    Video Signal Switch
    Analog Multiplexers, Demultipl
• Hall ICs
• Special Application ICs
    Motor Controller IC
    Interface and Driver Circuit
    Telecommunication Circuit
    Melody IC
    Alarm /Sound Generator IC
    Remote Controller IC
    Television Circuit
    Leakage Current Detector
    Automotive IC
    A-D or D-A Converters
    Radio and Cassette Recorder Ci
    Mouse&Keyboard Controller
    Transient Voltage Suppressors
    Sense Monitor
    Video Filter
    ZCB snubber
• Logic
    Power Mosfet
• SCRs
Home > Step Down Switching Regulators
UD05154 Datasheet






UTC UD05154 devices are synchronous step-down converters
optimized for small solution size and high efficiency. The devices
integrate switches capable of delivering an output current up to
1.5A. The devices are based on an adaptive on time with valley
current mode control scheme. Typical operating frequency is
1.5MHz at medium to heavy loads. The devices are optimized to
achieve very low output voltage ripple even with small external
components and feature an excellent load transient response.
During a light load, the UD05154 automatically enter into Power
Save Mode at the lowest quiescent current (50μA typ) to maintain
high efficiency over the entire load current range. In shutdown, the
current consumption is reduced to 1μA. The UD05154 provide an
adjustable output voltage via an external resistor divider. The
output voltage start-up ramp is controlled by an internal soft start,
typically 300 μs. Power sequencing is possible by configuring the
Enable pin. Other features like over current protection and over
temperature protection are built in.



* 2.7V to 5.5V Input Voltage Range
* 1.5MHz Typical Switching Frequency
* Output Current up to 1.5A
* Adaptive On-Time Current Control
* Power Save Mode for Light Load Efficiency

* 50μA Operating Quiescent Current
* Over Current Protection
* Internal Soft Startup of 300μs (Typ.)
* Adjustable Output Voltage
* Thermal Shutdown Protection

About us  |  Products  |  Contact us
Copyright 2011 UTC All received