Press Center
Home About us Products Support Quality & Certification Career Contact us
• Power Management
    Linear Regulators
    Low Dropout Linear Regulators
    DDR Termination Regulators
    Shunt Reference Regulators
    Step Down Switching Regulators
    Switching Regulator
    Step-Up DC-DC Converter
    PWM Controller
    White LED Driver
    Supervisory Circuit
    Voltage Detection and System R
    USB Power Switch
    Power Factor Control
    Li-Battery Protection or Charg
    FET Bias Controllers
    Combo IC
    Inverting DC-DC Converter
• Amplifier / Comparator
    Audio Amplifiers
    Operational Amplifier
    Voltage Comparator
• Analog Switches
    Video Signal Switch
    Analog Multiplexers, Demultipl
• Hall ICs
• Special Application ICs
    Motor Controller IC
    Interface and Driver Circuit
    Telecommunication Circuit
    Melody IC
    Alarm /Sound Generator IC
    Remote Controller IC
    Television Circuit
    Leakage Current Detector
    Automotive IC
    A-D or D-A Converters
    Radio and Cassette Recorder Ci
    Mouse&Keyboard Controller
    Transient Voltage Suppressors
    Sense Monitor
    Video Filter
    ZCB snubber
• Logic
    Power Mosfet
• SCRs
Home > Interface and Driver Circuit
UNTB0102 Datasheet





The UNTB0102 is a 2-bit, dual supply translating transceiver

with auto direction sensing, that enables bidirectional voltage level

translation. It features two 2-bit input-output ports (An and Bn), one

output enable input (OE) and two supply pins (VCCA and VCCB).

VCCA can be supplied at any voltage between 1.2V and 3.6V and

VCCB can be supplied at any voltage between 1.65V and 5.5V,

making the device suitable for translating between any of the low

voltage nodes (1.2V, 1.5V, 1.8V, 2.5V, 3.3V and 5.0V).

Pins An and OE are referenced to VCCA and pins Bn are

referenced to VCCB. A LOW level at pin OE causes the outputs to

assume a high-impedance OFF-state. This device is fully specified

for partial power-down applications using IOFF. The IOFF circuitry

disables the output, preventing the damaging backflow current

through the device when it is powered down.




* 1.2V to 3.6V on A Port and 1.65V to 5.5V on B Port

* IOFF circuitry provides partial Power-down mode operation

* Inputs accept voltages up to 5.5V

About us  |  Products  |  Contact us
Copyright 2011 UTC All received