Press Center
Home About us Products Support Quality & Certification Career Contact us
• Power Management
    Linear Regulators
    Low Dropout Linear Regulators
    DDR Termination Regulators
    Shunt Reference Regulators
    Step Down Switching Regulators
    Switching Regulator
    Step-Up DC-DC Converter
    PWM Controller
    White LED Driver
    Supervisory Circuit
    Voltage Detection and System R
    USB Power Switch
    Power Factor Control
    Li-Battery Protection or Charg
    FET Bias Controllers
    Combo IC
    Inverting DC-DC Converter
• Amplifier / Comparator
    Audio Amplifiers
    Operational Amplifier
    Voltage Comparator
• Analog Switches
    Video Signal Switch
    Analog Multiplexers, Demultipl
• Hall ICs
• Special Application ICs
    Motor Controller IC
    Interface and Driver Circuit
    Telecommunication Circuit
    Melody IC
    Alarm /Sound Generator IC
    Remote Controller IC
    Television Circuit
    Leakage Current Detector
    Automotive IC
    A-D or D-A Converters
    Radio and Cassette Recorder Ci
    Mouse&Keyboard Controller
    Transient Voltage Suppressors
    Sense Monitor
    Video Filter
    ZCB snubber
• Logic
    Power Mosfet
• SCRs
Home > Interface and Driver Circuit
UTXB0102 Datasheet





The UTXB0102 device is a 2-bit noninverting translator that uses

two separate configurable power-supply rails. The A port is designed

to track VCCA. VCCA accepts any supply voltage from 1.2V to 3.6V. The

B port is designed to track VCCB. VCCB accepts any supply voltage from

1.65V to 5.5V. This allows for universal low-voltage bidirectional

translation between any of the 1.2V, 1.5V, 1.8V, 2.5V, 3.3V, and 5V

voltage nodes. VCCA must not exceed VCCB.

When the output-enable (OE) input is low, all outputs are placed in

the high-impedance state.

This device is fully specified for partial-power-down applications

using IOFF. The IOFF circuitry disables the outputs when the device is

powered down. This inhibits current backflow into the device which

prevents damage to the device.

OE must be tied to GND through a pull-down resistor to assure the

high-impedance state during power up or power down; the minimum

value of the resistor is determined by the current-sourcing capability of

the driver.




* 1.2V to 3.6V on A Port and 1.65V to 5.5V on B Port (VCCA VCCB)

* VCC Isolation Feature – If Either VCC Input Is at GND, All Outputs Are in the High-Impedance State

* OE Input Circuit Referenced to VCCA

* Low Power Consumption, 4μA Max ICC

* IOFF Supports Partial-Power-Down Mode Operation

About us  |  Products  |  Contact us
Copyright 2011 UTC All received