Press Center
Home About us Products Support Quality & Certification Career Contact us
• Power Management
    Linear Regulators
    Low Dropout Linear Regulators
    DDR Termination Regulators
    Shunt Reference Regulators
    Step Down Switching Regulators
    Switching Regulator
    Step-Up DC-DC Converter
    PWM Controller
    White LED Driver
    Supervisory Circuit
    Voltage Detection and System R
    USB Power Switch
    Power Factor Control
    Li-Battery Protection or Charg
    FET Bias Controllers
    Combo IC
    Inverting DC-DC Converter
• Amplifier / Comparator
    Audio Amplifiers
    Operational Amplifier
    Voltage Comparator
• Analog Switches
    Video Signal Switch
    Analog Multiplexers, Demultipl
• Hall ICs
• Special Application ICs
    Motor Controller IC
    Interface and Driver Circuit
    Telecommunication Circuit
    Melody IC
    Alarm /Sound Generator IC
    Remote Controller IC
    Television Circuit
    Leakage Current Detector
    Automotive IC
    A-D or D-A Converters
    Radio and Cassette Recorder Ci
    Mouse&Keyboard Controller
    Transient Voltage Suppressors
    Sense Monitor
    Video Filter
    ZCB snubber
• Logic
    Power Mosfet
• SCRs
Home > PWM Controller
UC1010 Datasheet






The UTC UC1010 is designed to directly drive an ignition

IGBT and control the current and spark event of the coil. The coil

current is controlled via the input pin.

When the input of the UTC UC1010 is driven high, the output

is enabled, the IGBT will be turned on and start charging the coil.

The UTC UC1010 will sink a current (IIN) into the input pin based

on programmed current on the RA line.




* Signal Line Input Buffer

* Ground shift tolerance ±1.5 V

* Input spike filter

* Programmable maximum dwell time

* Programmable Input Pull down current

* Operation from Ignition or Battery line

* Control IGBT current limiting through Vsense pin

* Soft Shutdown following Max Dwell Time out

About us  |  Products  |  Contact us
Copyright 2011 UTC All received